Find More Posts by rev-speed. Qty Add to Cart. Injector current control to ensure both rapid injector operation and low injector temperature. The blue box has a solid red light, so I thought it was all go until I started the car. I’ve checked the injectors and wiring and they are all good. The activation input may be shared. Restriction Sales Region Unrestricted.
|Date Added:||14 June 2015|
|File Size:||33.35 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
Drives both peak and hold low impedance and saturated high impedance injectors.
Find More Posts by EdSales. Four channel injector driver with activation input. I’m using low impedance injectors with a stock ECU without any problems.
You just can’t see the problems.
Hondata Calibrations Now Available!
The instant I plug the Hondata P28 in and start it, it throws the code again. New engine harness and now tune is off?
Drives both peak and honcata low impedance and saturated high impedance injectors. The secondary injectors activate based on driving conditions, and may be larger than the primary injectors. The Hondata blue box has a solid red light and the chip is set in properly, which to me means that the ROM is good.
Restriction Sales Region Unrestricted.
At least that was the case for my P Injector current control to ensure both rapid injector operation and low injector temperature. I’ve honxata run the stock P28 with the stock injectors waaaay too lean and the stock P28 with the RC injectors waaaay too richbut both start with no CEL. Find More Posts by szumlins. The activation input may be shared. Staged injection requires ECU outputs. Send a private message to HRTuning.
I tried the stock P28 with both the cc injectors and the cc injectors, neither threw code 16 at me. Staged injection allows the use of primary and secondary injectors of different sizes.
Injector Driver Description Specification Features FAQ Installation The Hondata injector driver allows either the use of honcata or low impedance injectors without a resistor box either as injectors slaved to the ECU injector output or as staged injectors. You need to use one injector driver per set of injectors.
Hondata Calibrations Now Available! | DeatschWerks, LLC
Could I be wrong here? It is also possible to use two independent fuel systems for each set of injectors. I’m using low impedance injectors with a stock without any problems. The following errors occurred with your submission. Housing sealed to IP65 water resistant Activation input allows easy injector staging. No, because the way the Injector Driver controls current through the injectors will result in poor injector performance. Staged injection requires ECU outputs. The primary injectors are always used, and may be stock or other injectors with a rapid opening time and good spray pattern.
Hondata/Code 16 – Fuel Injector – Honda-Tech – Honda Forum Discussion
You need to use one injector driver per set of injectors. No, injwctor the way the Hondata Injector Driver controls current through the injectors will result in poor injector performance. Yes, it applies for the JDM P30 as well. For instance, the secondary injectors may use E85 or race gas.
Low impedance injectors draw more current than high impedance injectors and will eventually overheat if the injector driver output does not limit the current. The main concern is that the ECU injector driver outputs will be damaged as they are not designed for the amount of current a low impedance injector draws.
Four channel injector driver with activation input.